Beamer Panasonic PT-DZ21K
Model PT-DZ21KPower supply 200–240 V AC, 50/60 Hz (Max current requirements: 12 A @200 V)Power consumption 2,300 W (0.3 W with STANDBY MODE set to ECO,*1 9 Wwith STANDBY MODE set to NORMAL.)Dissipation BTU Max. 7,848 BTU/hour (without light output: 7,585 BTU/hour)DLP™ chip Panel size 24.4 mm(0.96 inches) diagonal(16:10 aspect ratio) 24.1 mm(0.95 inches) diagonal(4:3 aspect ratio) 21.6 mm(0.85 inches) diagonal(16:9 aspect ratio)Display method DLP™ chip x 3, DLP™ projection systemPixels 2,304,000(1,920 x 1,200) x 3,total of 6,912,000 pixels 1,470,000(1,400 x 1,050) x 3,total of 4,410,000 pixels 1,049,088(1,366 x 768) x 3,total of 3,147,264 pixelsLens Optional powered zoom and fixed-focus lensesLamp 465 W UHM lamp x 4, replacement cycle of up to 2,000 hours*2Screen size (diagonal) 1.78-25.4 m(70-1,000 inches),1.78–15.24 m(70–600 inches)with the ET-D75LE8,16:10 aspect ratio 1.78-25.4 m(70-1,000 inches),1.78–15.24 m(70–600 inches)with the ET-D75LE8,4:3 aspect ratio 1.78-25.4 m(70-1,000 inches),1.78–15.24 m(70–600 inches)with the ET-D75LE8,16:9 aspect ratioBrightness*3 20,000 lm(four-lamp) 17,000 lm(four-lamp)Center-to-corner uniformity*3 90%Contrast*3 10,000:1 (full on/off, with dynamic iris set to “3” )Resolution 1,920 x 1,200 pixels 1,400 x 1,050 pixels(Input signals thatexceed this resolution willbe converted to1,400 x 1,050 pixels.) 1,366 x 768 pixels(Input signals thatexceed this resolution willbe converted to1,366 x 768 pixels.)Scanning frequency SDI SD-SDI SMPTE ST 259 compliant, [YCBCR 4:2:2 10-bit] 480i, 576i -HD-SDI SMPTE ST 292 compliant,[YCBCR 4:2:2 10-bit] 720/50p, 720/60p, 1035/60i, 1080/50i,1080/60i, 1080/25p, 1080/24p, 1080/24sF, 1080/30p -Dual-link HD-SDI SMPTE ST 372 compliant,[RGB 4:4:4 12-bit /10-bit] 1080/50i, 1080/60i, 1080/25p,1080/24p, 1080/24sF, 1080/30p,[X´Y´Z´ 4:4:4 12-bit] 2,048 x 1,080/24p, 2,048 x 1,080/24sF -3G-SDI SMPTE ST 424 compliant,[YPBPR 4:2:2 10-bit] 1080/50p, 1080/60p,[RGB 4:4:4 12-bit /10-bit]1080/50i, 1080/60i, 1080/25p,1080/24p, 1080/24sF, 1080/30p -HDMI/DVI-D 480p, 576p, 720/60p, 720/50p, 1080/60i, 1080/50i, 1080/24p,1080/24sF, 1080/25p, 1080/30p, 1080/60p, 1080/50p,VGA (640 x 480)–WUXGA*4 (1,920 x 1,200),compatible with non-interlaced signals only, dot clock: 25–162 MHzRGB fH: 15–100 kHz, fV: 24–120 Hz, dot clock: 20–162 MHzYPBPR (YCBCR)fH: 15.75 kHz, fV: 60 Hz [480i (525i)]fH: 15.63 kHz, fV: 50 Hz [576i (625i)]fH: 45.00 kHz, fV: 60 Hz [720 (750)/60p]fH: 33.75 kHz, fV: 60 Hz [1035/60i]fH: 28.13 kHz, fV: 50 Hz [1080 (1125)/50i]fH: 27.00 kHz, fV: 24 Hz [1080/24p]fH: 33.75 kHz, fV: 30 Hz [1080/30p]fH: 56.25 kHz, fV: 50 Hz [1080/50p]fH: 31.50 kHz, fV: 60 Hz [480p (525p)]fH: 31.25 kHz, fV: 50 Hz [576p (625p)]fH: 37.50 kHz, fV: 50 Hz [720 (750)/50p]fH: 33.75 kHz, fV: 60 Hz [1080 (1125)/60i]fH: 28.13 kHz, fV: 25 Hz [1080/25p]fH: 27.00 kHz, fV: 48 Hz [1080/24sF]fH: 67.50 kHz, fV: 60 Hz [1080/60p]Video/Y/C fH: 15.75 kHz, fV: 60 Hz [NTSC/NTSC4.43/PAL-M/PAL60],fH: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM]Optical axis shift*5 Vertical ±55 % (±44 % withthe ET-D75LE6)from center of screen(powered) ±50 % (±40 % withthe ET-D75LE6)from center of screen(powered) ±70 % (±60 % withthe ET-D75LE6)from center of screen(powered)Horizontal ±20 % (±15 % withthe ET-D75LE6)from center of screen(powered) ±30 % (±20 % with the ET-D75LE6)from center of screen (powered)Keystone correction range Vertical: ±40°*6, horizontal: ±15° Vertical: ±40°*6Keystone correction rangewith optional Upgrade Kit Vertical: ±45°*6*8, horizontal: ±40°*7*8 -Installation Ceiling/floor, front /rearTerminals SDI 1 IN BNC x 1 (3G/HD/SD-SDI) -SDI 2 IN BNC x 1 (HD/SD-SDI) -3D SYNC IN/OUT BNC x 1 (3D timing signal) -3D SYNC OUT BNC x 1 (3D timing signal) -DVI-D IN DVI-D 24-pin x 1 (DVI 1.0 compliant, compatible with HDCP,compatible with single link only)HDMI IN HDMI 19-pin x 1 (Deep Color, compatible with HDCP)RGB 1 IN BNC x 5 (RGB/YPBPR/YCBCR/YC x 1)RGB 2 IN D-Sub HD 15-pin (female) x 1 (RGB/YPBPR/YCBCR x 1)VIDEO IN BNC x 1 (composite video)SERIAL IN D-sub 9-pin (female) x 1 for external control (RS-232C compliant)SERIAL OUT D-sub 9-pin (male) x 1 for link control (RS-232C compliant)REMOTE 1 IN M3 x 1 for wired remote controlREMOTE 1 OUT M3 x 1 for link control (for wired remote control)REMOTE 2 IN D-sub 9-pin (female) x 1 for external control (parallel)LAN RJ-45 x 1 (for network connection, 10Base-T/100Base-TX, compliant with PJLink™)Cabinet materials Molded plasticDimensions (W x H x D) 620 x 291*9 x 800 mm (24-7/16″ x 11-15/32″*9 x 31-1/2″) (optional lens not included)Weight*10 Approximately 43 kg (94.8 lbs) (optional lens not included)Shipping dimensions(W x H x D) PT-DZ21KU / DS20KU / DW17KUPT-DZ21KEJ / DS20KEJ / DW17KEJ 965 x 418 x 865 mm (38″ x 16-15/32″ x 34-1/16″)PT-DZ21KE / DS20KE / DW17KE 946 x 402 x 846 mm (38″ x 15-13/16″ x 33-5/16″)Shipping weight PT-DZ21KU / DS20KU / DW17KU 53 kg (116.8 lbs)PT-DZ21KEJ / DS20KEJ / DW17KEJ 54 kg (119.0 lbs)PT-DZ21KE / DS20KE / DW17KE 51 kg (112.4 lbs)Operation noise*3 49 dB (quad lamp operation)Operating environment Operating temperature: 0–45°C (32–113°F)*11,operating humidity: 10– 80 % (no condensation)Applicable software Logo Transfer Software,Multi Projector Monitoring & Control Software,Geometry Manager Pro (included in the ET-UK20) Logo Transfer Software,Multi ProjectorMonitoring & Control SoftwareSupplied accessories Power cord with secure lock, wireless/wired remote control unit, batteries (R6/AA type x 2)